Honda Odyssey Service Manual: Installation

Honda Odyssey Service Manual / Electrical / Charging / Over-Run Alternator Decoupler (OAD) Pulley Removal and Installation / Installation

  1. Loosely tighten the OAD pulley (A), then insert the alternator OAD pulley holder (B) into the OAD pulley.

    2. B07AAB-TK8A100A

  1. Place a 10 mm deep socket wrench (A) through center of the alternator OAD pulley holder (B), onto the hex on the end of the alternator shaft.

    2. ABC

  2. Hold the alternator OAD pulley holder with a 17 mm wrench (C), then tighten the alternator shaft counterclockwise to the specified torque.

    Specified Torque:

    80 N·m (8.2 kgf·m, 59 lbf·ft)

  1. Install the new OAD pulley seal cap (A).

    NOTE:

    • When installing do not distort the OAD pulley seal cap.

    • Make sure to check that the cap is installed securely.

    2. AReplace.

  1. Install the alternator.

    Removal

    Data and Communication Network

    See More:

    Honda Odyssey Service Manual > Gauges: Gauge Control Module Replacement
    NOTE: Before replacing the gauge control module, retrieve the ODO data from the gauge control module with the HDS. Turn the ignition switch to LOCK (0). Remove the instrument visor. Remove the three screws from the gauge control module (A). BA Disconnect the 32P connector (B) from the gauge control ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2024 Copyright www.hodyssey.net
    0.009