Honda Odyssey Service Manual: Recirculation Control Motor Replacement

Honda Odyssey Service Manual / HVAC / Ventilation Doors / Recirculation Control Motor Replacement

Removal

  1. Remove the blower unit.

  1. Remove the self-tapping screws and the recirculation control motor (A) from the blower unit.

    2. A

Installation

  1. Make sure the damper lever pins in the motor lever are visible through the holes. Make sure the recirculation door and linkage move smoothly.

    2. Check here.

  1. While holding the recirculation control motor (A), install the self-tapping screws.

    2. A

  1. Install the blower unit.

  1. After installation, make sure the motor runs smoothly.

    Rear Mode Control Motor Replacement

    See More:

    Honda Odyssey Service Manual > Seating: Headrests
    Front Seat Active Head Restraint Inspection NOTE: If the vehicle has been in a collision, always inspect the active head restraint, even if they appear reusable, by doing the following procedure. Move the seat-back to the fully upright position. Raise the head restraint to the highest position. Appl ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0191