Honda Odyssey Service Manual: BSI Control Unit Removal/Installation

Honda Odyssey Service Manual / Accessories / Driver Assist / Blind Spot Monitor / BSI Control Unit Removal/Installation

  1. Remove the left rear side trim panel.

  1. Remove the BSI control unit (A).

    1. Disconnect the BSI control unit 16P connector (B) and detach the harness clip (C).

    1. Remove the bolt.

    2. BCA9.4 N·m(0.96 kgf·m,6.9 lbf·ft)

  2. Install the BSI control unit in the reverse order of removal.

    Blind Spot Monitor

    BSI OFF Switch Test/Removal/Installation

    See More:

    Honda Odyssey Service Manual > Seat Position Sensors: Driver's Seat Position Sensor Operation Check
    NOTE: Check the driver's seat position sensor operation after the driver's seat position sensor replacement or removal. Make sure the driver's seat is in the full forward position. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode. Connect the HDS to ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0101