Honda Odyssey Service Manual: FCW/LDW Camera Unit Aiming

Special Tools Required

  • Honda Diagnostic System (HDS) TDSGDS2200
  • Service Point Calibration (SPC)

The FCW/LDW camera must be re-aimed whenever the FCW/LDW camera unit is removed or replaced, or the windshield is removed or replaced, or if an aiming error occurs.
The FCW indicator comes on if the aiming process is not completed correctly, there is dust/dirt on the camera unit surface, or if an aiming error occurs:

  • FCW/LDW Camera Unit Aiming Incomplete: DTC B2A60-54

  • FCW/LDW Camera Dirty: DTC B2A60-97

Before Aiming:

  • Aiming the FCW/LDW camera requires the HDS.

  • Clean the windshield.

  • Make sure that all of the tire sizes are correct and inflated to the proper pressure.

  • Make sure the fuel tank is full.

  • Remove all cargo from the vehicle except the spare tire and the tool kit.

  • Make sure the steering wheel is pointed straight ahead, and do not turn it after setting up the vehicle.

    Lane Departure Warning

    Aiming (Service Point Calibration)

    See More:

    Honda Odyssey Service Manual > Over-Run Alternator Decoupler (OAD) Pulley Removal and Installation: Installation
    Loosely tighten the OAD pulley (A), then insert the alternator OAD pulley holder (B) into the OAD pulley. B07AAB-TK8A100A Place a 10 mm deep socket wrench (A) through center of the alternator OAD pulley holder (B), onto the hex on the end of the alternator shaft. ABC Hold the alternator OAD pulley ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0071