Honda Odyssey Service Manual: Aiming (Service Point Calibration)

NOTE: Do the service calibration on a flat and straight road that has several lanes where you can drive at least 25 mph (40 km/h). You must complete the aiming procedure within 10 minutes. The aiming procedure may fail if you take too long, if the weather is poor (rain, fog, or snow), or the white or yellow lines are not visible because of reflections from a wet road.

1. Press the engine start/stop button to select the OFF mode.

2. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (A) located under the driver's side of the dashboard.

3. Press the engine start/stop button to select the ON mode.

4. Make sure the HDS communicates with the vehicle and the FCW/LDW camera unit. If it does not communicate, go to the DLC circuit troubleshooting.

5. Start the engine. At this time, the FCW and LDW indicators come on.

6. Follow the HDS onscreen instructions and confirm the results in the table below.

Service Point Calibration Status (Re-Aiming)

STATE	Indicator
While aiming	Blink
Aiming is completed	OFF
Aiming is failure	ON




Service Point Calibration Status (New unit)

STATE	Indicator
Vehicle ON mode	ON for 16 seconds   then Blink
While aiming	Blink
Aiming is completed	OFF
Aiming is failure	ON