Honda Odyssey Service Manual: Headlight Leveling Motor Replacement

  1. For the right side, move the radiator reservoir.

  1. Disconnect the 3P connector (A) from the headlight leveling motor, then turn the leveling motor (B) 45 ° counterclockwise (left side) or clockwise (right side) to remove it.

  2. AB
  3. Remove the headlight high beam bulb and pull the headlight reflector slightly, then remove the headlight leveling motor.

  4. Install the headlight leveling motor in the reverse order of removal.

  5. After installing, do the headlight initial position learning.

    Headlight Leveling Control Unit Input Test/Replacement

    Headlight Leveling System

    See More:

    Honda Odyssey Service Manual > Over-Run Alternator Decoupler (OAD) Pulley Removal and Installation: Removal
    Remove the alternator. Clamp the alternator firmly in a vise. Remove the over-run alternator decoupler (OAD) pulley seal cap (A) by piercing the center of the rubber cap with a flat screwdriver and prying it loose. NOTE: While the cap is off, the grease inside the OAD pulley is exposed. Do not wipe ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0077