Honda Odyssey Service Manual: Rear Inner Fender Replacement

Honda Odyssey Service Manual / Body / Body Exterior / Rear Inner Fender Replacement

NOTE:

  • Put on gloves to protect your hands.

  • Take care not to scratch the body or the rear bumper.

  • When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

  1. Remove the rear wheel.

  1. Remove the rear inner fender (A).

    1. Remove the screws (B) and the bolts (C).

    1. Detach the clips (D, E).

    1. Remove the nut (F).

  2. Fastener LocationsA6 x 1.0 mm9.3 N·m(0.95 kgf·m, 6.9 lbf·ft)BBECBBCCB ? : ScrewC ? : Bolt, 5E ? : Clip, 3D ? : Clip, 1FBCEECDB(Left side)Left, 6Right, 5F ? : Clip, 1
  3. Install the inner fender in the reverse order of removal, and note these items:

    • If the clips are damaged or stress-whitened, replace them with new ones.

    • Push the clips into place securely.

    Front Inner Fender Replacement

    Front Door Glass Outer Weatherstrip Replacement

    See More:

    Honda Odyssey Service Manual > Fuses Junctions and Relays: Under-Hood Fuse/Relay Box Removal and Installation
    Special Tools Required Relay Puller 07AAC-000A2A1 or 07AAC-000A1A0 NOTE: The under-hood fuse/relay box is a part of the right engine compartment wire harness, and it cannot be replaced by itself. Removal Do the battery terminal disconnection procedure. Remove the bolt (A), and release the tabs (B), ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2021 Copyright www.hodyssey.net
    0.02