Honda Odyssey Service Manual: Disassembly

  1. Drain the fluid from the power steering pump.

  1. Remove the power steering pump.

  1. Hold the power steering pump (A) in a vise with soft jaws (B), then hold the pulley (C) with the pulley holder (D), and remove the pulley nut (E) and pulley. Be careful not to damage the pump housing with the jaws of the vise.

  2. AD07ZAB-S5A0100CBE
  3. Remove the inlet joint and 14.8 mm O-ring.

  4. Loosen the flow control valve cap, and remove the cap, 16.7 mm O-ring, flow control valve, and flow control valve spring.

  5. Remove the pump cover and pump cover seal.

  6. Remove the cam ring, outer case, rotor, vanes, side plate, and 23.8 mm O-ring.

  7. Remove the pump housing cap, 12.7 mm O-ring, and the pump preload spring.

  8. Remove the 40 mm snap ring, then remove the driveshaft by tapping the shaft end with a soft face hammer.

  9. Remove the pump seal from the pump housing.

    Exploded View

    Inspection

    See More:

    Honda Odyssey Service Manual > Power Seat Controls: Power Seat Control Unit Input Test/Replacement
    NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing. If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. Turn the ignition switc ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2021 Copyright www.hodyssey.net
    0.0227