Honda Odyssey Service Manual: Suspension Stroke Sensor Replacement

Honda Odyssey Service Manual / Chassis / Brake Control and Vehicle Dynamics / Suspension Stroke Sensor Replacement

  1. Raise the vehicle, make sure it is securely supported.

  1. Disconnect the 3P connector (A) from the suspension stroke sensor (B).

    2. Front

    ABDo not disassemble.D9.4 N?m (0.96 kgf?m, 6.9 lbf?ft)Replace.C

    Rear

    A9.4 N?m (0.96 kgf?m, 6.9 lbf?ft)Do not disassemble.BCD

  2. Remove the bolt(s) (C) and the nut (D), then remove the suspension stroke sensor.

  3. Install the sensor in the reverse order of removal.

  4. After installing, do the headlight initial position learning.

    BSI OFF Switch Test/Removal/Installation

    Wheel Speed Sensor Replacement

    See More:

    Honda Odyssey Owners Manual > Driving Position Memory System: Storing a Position in Memory
    1. Adjust the driver’s seat and the outside mirrors to the desired position, and turn the ignition switch to ON . 2. Press the SET button. ►You will hear the beeper, and the memory button indicator light will blink. 3. Press and hold memory button 1 or 2 within five seconds of pressing the ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0186