The following products and systems on your vehicle emit radio waves when in operation.
Each of the above complies with the appropriate requirements or the required standards of FCC (Federal Communications Commission) and Industry Canada Standard, described below: As required by the FCC: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Industry Canada Standard RSS-Gen/210/310. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. |
Honda Odyssey Service Manual > Wheels/Tires: Wheel Runout Inspection
Raise and support the vehicle. Check for bent or deformed wheels. Set up the dial gauge as shown, and measure the axial runout by turning the wheel. Front and rear wheel axial runout: Standard: Steel wheel: 0-0.7 mm (0.0-0.028 in) Aluminum wheel: 0-0.3 mm (0-0.012 in) Service limit: 2.0 mm (0.079 in ...