Honda Odyssey Service Manual: BSI OFF Switch Test/Removal/Installation

Honda Odyssey Service Manual / Accessories / Driver Assist / Blind Spot Monitor / BSI OFF Switch Test/Removal/Installation

  1. Push out the BSI OFF switch (A) from the back of the dashboard, and disconnect the BSI OFF switch 6P connector (B).

    2. AB

  1. On the switch side, check for continuity between the BSI OFF switch 6P connector terminal in each switch position according to the table.

    2. 6 5 4 3 2 1 BSI OFF SWITCH 6P CONNECTORTerminal side of male terminals
    TerminalPosition45PRESSEDRELEASED

  • If the switch does not work as described in the table, replace the switch.

  • If the switch tests OK, go to step 3.

  1. On the switch side, check for continuity between the BSI OFF switch 6P connector terminals No. 1 and No. 2.   There should be continuity at all times.

    2. 6 5 4 3 2 1 BSI OFF SWITCH 6P CONNECTORTerminal side of male terminals?

  1. If the continuity is not as specified, remove the cover (A), and replace the bulb (B).

    2. BA

  1. Install the BSI OFF switch in the reverse order of removal.

    BSI Control Unit Removal/Installation

    BSI Radar Unit Aiming Inspection

    See More:

    Honda Odyssey Service Manual > Seating: Headrests
    Front Seat Active Head Restraint Inspection NOTE: If the vehicle has been in a collision, always inspect the active head restraint, even if they appear reusable, by doing the following procedure. Move the seat-back to the fully upright position. Raise the head restraint to the highest position. Appl ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0172