Honda Odyssey Service Manual: Audio Display Visor Removal/Installation

Honda Odyssey Service Manual / Accessories / Electronics / Audio Display Visor Removal/Installation

NOTE:

  • Do this procedure in a clean place free from dirt.

  • Wear latex or vinyl gloves when doing this procedure (Do not use fabric gloves).

  • When removing the audio display visor, do not touch the LCD facing.

  • If there is dirt on the LCD facing, clean it using compressed air.

  • When installing the audio display visor onto the LCD assembly, be careful not to touch the LCD facing.

  • Check that the audio display visor and the LCD assembly are properly installed.

  • Since the LCD assembly and the audio display visor are installed at an angle, be sure that the screws are properly seated. If not properly seated, tighten the screws.

  • Check that the audio display unit assembly has no damage.

  • When removing the audio display visor, do not hold the LCD facing down.

  1. Remove the audio display-USB adapter control unit.

  1. Remove the screws and the LCD assembly (A) from the audio display visor (B).

  2. AB
  3. Install the audio display visor reverse order of removal.

    Wireless Remote Control Battery Replacement

    Audio Switch Panel Removal/Installation

    See More:

    Honda Odyssey Service Manual > Crash Sensors: Yaw Rate-Acceleration Sensor Replacement
    NOTE: Do not damage or drop the sensor as it is sensitive. Do not use power tools when replacing the sensor. Check the sensor bracket for a deformation. Turn the ignition switch to LOCK (0). Remove the center lower console. Remove the yaw rate-acceleration sensor (A). AB6 x 1.0 mm9.4 N·m (0.96 kgf ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2022 Copyright www.hodyssey.net
    0.0068