Honda Odyssey Service Manual: Special Tools Required

  • KTC Trim Tool Set SOJATP2014
  • *Available through the Honda Tool and Equipment Program; call 888-424-6857

NOTE:

  • Put on gloves to protect your hands.

  • Take care not to scratch the door.

  • Take care not to damage the door glass outer weatherstrip.

  • Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

  1. Remove the sliding door upper molding.

  1. Pull the top of the door rear sash outer trim (A) to detach the clips, and release the trim from between the door glass outer weatherstrip (B) and the door, then remove the trim.

  2. Fastener LocationsAB? : Clip, 5??
  3. Install the trim in the reverse order of removal, and push the clips into place securely.

    Vertical and Horizontal Adjustment at the Rear

    Sliding Door Subseal Replacement

    See More:

    Honda Odyssey Owners Manual > Operating the Switches Around the Steering Wheel: Wipers and Washers
    The windshield wipers and washers can be used when the ignition switch is in ON . ■ MIST The wipers run at high speed until you release the lever. ■ Wiper switch (OFF, INT, LO, HI) Change the wiper switch setting according to the amount of rain. ■ Adjusting the delay Turn the adju ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0104