Honda Odyssey Service Manual: Power Tailgate Drive Unit Replacement

Honda Odyssey Service Manual / Body / Doors and Enclosures / Trunklid/Tailgate/Cargo Doors / Power Tailgate Drive Unit Replacement

  1. Remove the C-pillar trim.

  1. Remove the upper trim and the left tailgate side trim.

  1. Note the alignment marks on the drive unit and the arm unit, then carefully remove the two bolts (A), nut (B), and the arm unit (C).

    2. CB12 x 1.25 mm109.0 N·m (11.11 kgf·m, 80.41 lbf·ft)A2.2 N·m (2.2 kgf·m, 16.0 lbf·ft)

  1. Disconnect the connectors (A), and remove the three bolts (B) and the drive unit (C).

    2. BAC

  1. Install in the reverse order of removal.

    NOTE: Align the marks (A) of the drive unit and arm unit to install the arm unit to the original alignment.

    2. A
    Power Tailgate Inside Switch Test/Replacement

    Power Tailgate Pinch Sensor Replacement

    See More:

    Honda Odyssey Service Manual > Ventilation Doors: Rear Mode Control Motor Replacement
    SRS components are located in this area. Review the SRS component locations   and the precautions and procedures   before doing repairs or service. Remove the rear HVAC unit. Disconnect the 7P connector (A) from the rear mode control motor (B). Remove the self-tapping screws and ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0094