Honda Odyssey Service Manual: Front Inner Fender Replacement

Honda Odyssey Service Manual / Body / Body Exterior / Front Inner Fender Replacement

NOTE:

  • Put on gloves to protect your hands.

  • Take care not to scratch the body or the front bumper.

  • When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

  1. Remove the front wheel.

  1. Remove the front inner fender (A).

    1. Canada models: Remove the screws (B), then remove the front splash guard (C).

    1. Remove the screws (D).

    1. Remove the bolts (E).

    1. Detach the clips (F, G, H).

      NOTE: To release the clips H, pry up on the center pin at the notch (I).

  2. Fastener LocationsAG6 x 1.0 mm9.3 N·m(0.95 kgf·m, 6.9 lbf·ft)GGEDDB ? : Screw, 4G ? : Clip, 7GGDDFGDF ? : Clip, 3E ? : Bolt, 3EDFDEFHHIIH ? : Clip, 3D ? : Screw, 7HGBBBCanada modelsBC
  3. Install the inner fender in the reverse order of removal, and note these items:

    • If the clips are damaged or stress-whitened, replace them with new ones.

    • Push the clips into place securely.

    Roof Molding Replacement

    Rear Inner Fender Replacement

    See More:

    Honda Odyssey Owners Manual > Replacing Light Bulbs: Brake/Rear Side Marker/Taillight and Rear Turn Signal Light Bulbs
    When replacing, use the following bulbs. Brake/Rear Side Marker/Taillight: 21/5 W Rear Turn Signal Light: 21 W (Amber) 1. Remove the mounting bolts. 2. Place one hand on the outer corner of the taillight assembly and other hand on the lower edge of the taillight, near the cargo area. 3. Pull the out ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.011