Honda Odyssey Service Manual: How to Release Locked Odometer Mileage to the Original Gauge Control module

Honda Odyssey Service Manual / Body / Driver Info & Control / Gauges / How to Release Locked Odometer Mileage to the Original Gauge Control module

If, after you attempt to transfer mileage to a new gauge assembly, the odometer display has dashes (---), is garbled, or shows an incorrect value, the original gauge control module can be unlocked and restored to its original state In this way, it can be used again for additional attempts to transfer the mileage:

  1. Confirm that you have the latest HDS version of software.

  1. Make sure that the HDS shows the correct VIN for the vehicle you are working on.

  1. With the ignition switch in LOCK (0), reconnect the original gauge control module.

  1. Completely re-boot the HDS.

  1. Clear any stored DTCs.

  1. Navigate to BODY ELECTRIC/GAUGES/GAUGE CONTROL MODULE REPLACEMENT (ODO REWRITE, etc.).

  1. Select 3. RELEASING LOCKED ODO VALUE.

  1. Follow the prompts and the odometer mileage is restored.

  1. Start over and make sure the screen prompts are followed.

    Rewriting the ODO Data on a New Gauge Control Module

    Fuel Pump/Fuel Gauge Sending Unit Replacement

    See More:

    Honda Odyssey Service Manual > Data and Communication Network: Rear Fuse Box (Rear MICU) Removal and Installation
    NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing. Removal Do the battery terminal disconnection procedure. Remove the left rear side trim panel. Disconnect the connectors from the rear fuse ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0057