Honda Odyssey Service Manual: Driver's Side

Honda Odyssey Service Manual / Body / Body Interior / Dashboard Assembly / Driver's Side

  1. Disconnect the roof wire harness connector (A) from the A-pillar.

    2. A

  1. From under the dash, disconnect the following connectors:

    • Left side wire harness connectors (A)

    • Left engine compartment wire harness connectors (B)

    • Driver's door wire harness connectors (C)

    2. AABBC

  1. From under the dash, remove the mounting bolts.

    2. Fastener Locations? : Bolt, 28 x 1.25 mm22 N·m(2.2 kgf·m, 16 lbf·ft)

    Dashboard/Steering Hanger Beam Removal/Installation

    Middle Area

    See More:

    Honda Odyssey Service Manual > Over-Run Alternator Decoupler (OAD) Pulley Removal and Installation: Removal
    Remove the alternator. Clamp the alternator firmly in a vise. Remove the over-run alternator decoupler (OAD) pulley seal cap (A) by piercing the center of the rubber cap with a flat screwdriver and prying it loose. NOTE: While the cap is off, the grease inside the OAD pulley is exposed. Do not wipe ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0082