Honda Odyssey Service Manual: Power Lumbar Support Switch Test/Replacement

Honda Odyssey Service Manual / Body / Seating / Seat Controls / Power Seat Controls / Power Lumbar Support Switch Test/Replacement

NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing.

  1. Remove the driver's recline cover.

  1. Disconnect the 5P connector from the lumber support switch (A), then separate the cover (B).

    2. 1 2 3 4 5 AB

  1. Check for continuity between the terminals in each switch position according to the table.

    2. ForwardBackwardTerminalPosition12345*???????*?

    *: There is continuity without operating a switch.

  2. If the continuity is not as specified, replace the switch.

  3. Install the switch in the reverse order of removal.

    Power Seat Controls

    Power Seat Control Unit Input Test/Replacement

    See More:

    Honda Odyssey Owners Manual > Maintenance Under the Hood: Opening the Hood
    1. Park the vehicle on a level surface, and set the parking brake. 2. Pull the hood release handle under the lower left corner of the dashboard. ► The hood will pop up slightly. 3. Slide the hood latch lever in the center of the hood to release the lock mechanism, and open the hood. 4. Remove ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0193