Honda Odyssey Service Manual: Exploded View

Honda Odyssey Service Manual / Chassis / Steering / Hydraulic Power Steering Pump Overhaul / Exploded View

8 x 1.25 mm20 N·m (2.0 kgf·m, 15 lbf·ft)PUMP COVER3 mm ROLL PIN2 mm ROLL PINPUMP COVER SEALReplace.CAM RINGVANES(11 plates)ROTOR23.8 x 2.4 mmO-RINGReplace.SIDE PLATEOUTER CASE57.2 x 1.9 mm O-RINGReplace.12.7 x 1.8 mm O-RINGReplace.INLET JOINT6 x 1.0 mm11 N·m (1.1 kgf·m, 8 lbf·ft)FLOW CONTROL VALVE SPRING16.7 x 1.8 mm O-RINGReplace.PUMP HOUSINGPUMP SEALReplace.BALL BEARING40 mm SNAP RINGDRIVESHAFTPULLEYPULLEY NUT64 N·m(6.5 kgf·m, 47 lbf·ft)FLOW CONTROL VALVE CAP49 N·m (5.0 kgf·m, 36 lbf·ft)FLOW CONTROL VALVEPUMP HOUSING CAP29 N·m (3.0 kgf·m, 22 lbf·ft)PUMP PRELOAD SPRING14.8 x 1.9 mm O-RINGReplace.RUBBER SEAL (Black color)Replace.SLIPPER SEAL (White color)Replace.13.0 x 1.9 mm O-RINGReplace.

Special Tools Required

  • Pulley Holder 07ZAB-S5A0100
  • Driver Handle, 15 x 135L 07749-0010000
  • Bearing Driver Attachment, 32 x 35 mm 07746-0010100

NOTE: Refer to the Exploded View as needed during the following procedure.

    Hydraulic Power Steering Pump Overhaul

    Disassembly

    See More:

    Honda Odyssey Service Manual > Over-Run Alternator Decoupler (OAD) Pulley Removal and Installation: Removal
    Remove the alternator. Clamp the alternator firmly in a vise. Remove the over-run alternator decoupler (OAD) pulley seal cap (A) by piercing the center of the rubber cap with a flat screwdriver and prying it loose. NOTE: While the cap is off, the grease inside the OAD pulley is exposed. Do not wipe ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0076