Honda Odyssey Service Manual: Steering Gearbox Removal and Installation

Honda Odyssey Service Manual / Chassis / Steering / Steering Gearbox Removal and Installation

Special Tools Required

  • Ball Joint Thread Protector, 12 mm 07AAF-SDAA100
  • Ball Joint Remover, 28 mm 07MAC-SL0A202
  • Subframe Adapter VSB02C000016
  • *Available through the Honda Tool and Equipment Program, 888-424-6857.

Note these items during removal:

  • Using clean solvent and a brush, wash any oil and dirt off the valve body unit, it's lines, and the end of the steering gearbox. Blow dry with compressed air.

  • Lower the front subframe from the body, and remove the steering gearbox through the gap produced by lowering the front subframe.

    Exploded View

    Steering Linkage and Gearbox Inspection

    See More:

    Honda Odyssey Owners Manual > Cruise Control: To Adjust the Vehicle Speed
    Increase or decrease the vehicle speed using the or buttons on the steering wheel. • Each time you press the button, the vehicle speed is increased or decreased by about 1 mph (1.6 km/h). • If you keep the button pressed, the vehicle speed increases or decreases until you release it. This speed ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0095