Remove the brake caliper bracket mounting bolts (B), then remove
the caliper assembly (C) from the knuckle. To prevent damage to the
caliper assembly or the brake hose, use a short piece of wire to hang
the caliper assembly from the undercarriage. Do not twist the brake hose
excessively.
Remove the two washers (A).
NOTE: During installation, make sure the washers are installed between the brake caliper bracket and the knuckle.
Release the parking brake lever fully, and remove the rear brake disc/drum.
Remove the hub bearing unit (A) and the O-ring (B).
Check the hub bearing unit for damage and cracks.
Install the hub bearing unit in the reverse order of removal, and note these items:
Use a new O-ring on reassembly.
Before installing the brake disc/drum, clean the mating surfaces
between the hub bearing unit and the inside of the brake disc/drum.
Before installing the wheel, clean the mating surfaces between the brake disc/drum and the inside of the wheel.
Check the wheel alignment, and adjust it if necessary.
Honda Odyssey Owners Manual > Rear Seats: Tucking away the One-Motion Third row magic Seat®
1. Store the center seat belt first. Insert a key into the slot on the side of the anchor buckle. 2. Retract the seat belt into the holder on the ceiling. 3. Lower the head restraints to their lowest position. 4. The right and left halves can be tucked away separately. Pull either strap to release ...
