Honda Odyssey Service Manual: Exploded View

Honda Odyssey Service Manual / Chassis / Suspension / Rear Knuckle/Hub Bearing Unit Replacement / Exploded View

12 x 1.25 mm98 N·m(10.0 kgf·m, 72 lbf·ft)14 x 1.5 mm78 N·m(8.0 kgf·m, 58 lbf·ft)KNUCKLECheck for deformation and damage.WASHERCheck for deformation and damage.HUB BEARING UNIT(MAGNETIC ENCODER)Check for faultymovement and wear.REAR BRAKE DISC/DRUMCheck for wear and rust.FLATHEAD SCREW6 x 1.0 mm9.3 N·m(0.95 kgf·m,6.9 lbf·ft)BACKING PLATECheck for corrosion, deformation, rust, and damage.PARKING BRAKE SHOE ASSEMBLYO-RING Replace.

Special Tools Required

  • Ball Joint Thread Protector, 12 mm 07AAF-SDAA100
  • Ball Joint Remover, 28 mm 07MAC-SL0A202

NOTE: Refer to the Exploded View as needed during the following procedure.

    Rear Knuckle/Hub Bearing Unit Replacement

    Hub Bearing Unit Replacement

    See More:

    Honda Odyssey Service Manual > Brake Control and Vehicle Dynamics: Wheel Speed Sensor Replacement
    Front Turn the ignition switch to LOCK (0). Remove the grommet (A), then disconnect the wheel speed sensor connector (B). ABCD6 x 1.0 mm9.3 N·m (0.95 kgf·m, 6.9 lbf·ft) Remove the clamp (C), the clip, and the wire guide rubber. Remove the bolt and the wheel speed sensor (D). Install the wheel spe ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0234