Honda Odyssey Service Manual: Removal

  1. Raise and support the vehicle.

  1. Remove the front wheel.

  1. Remove the wire guide rubber (A) and the clip (B) from the damper (C). Do not disconnect the wheel speed sensor connector.

  2. 8 x 1.25 mmABCD
  3. Remove the brake hose bracket (D) from the damper.

  1. Remove the flange nut (A), while holding the joint pin (B) with a hex wrench (C), and disconnect the stabilizer link (D) from the damper.

  2. BCDA12 x 1.25 mm
  1. Remove the damper pinch bolts (A) and flange nuts (B) from the damper.

    NOTE: Do not allow the knuckle to rotate too far outward. This may allow the driveshaft inboard joint to come apart.

  2. BReplace.A16 x 1.5 mmReplace.
  1. Remove the cowl top wiper cover (A), then remove the flange nuts (B) from the top of the damper. Do not let the damper/spring drop down under its own weight.

  2. AB10 x 1.25 mmReplace.
  1. Remove the damper/spring (A).

    NOTE:

    • The left and right damper springs are different. Mark the springs L and R before you continue.

    • Be careful not to damage the body.

  2. A

    Front Damper/Spring Removal and Installation

    Installation

    See More:

    Honda Odyssey Service Manual > Accessory Outlets: Front Accessory Power Socket Test/Replacement
    NOTE: If all accessory power sockets do not work, check the No. A2-2 (50 A) fuse in the main under-hood fuse box, and No. C13 (7.5 A) fuse in the driver's under-dash fuse/relay box first. Gently press the tabs (A) and remove the socket (B). AB Disconnect the 2P connector (A) from the front accessory ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.014