Honda Odyssey Service Manual: BSI OFF Switch Test/Removal/Installation

Honda Odyssey Service Manual / Chassis / Brake Control and Vehicle Dynamics / BSI OFF Switch Test/Removal/Installation

  1. Push out the BSI OFF switch (A) from the back of the dashboard, and disconnect the BSI OFF switch 6P connector (B).

    2. AB

  1. On the switch side, check for continuity between the BSI OFF switch 6P connector terminal in each switch position according to the table.

    2. 6 5 4 3 2 1 BSI OFF SWITCH 6P CONNECTORTerminal side of male terminals
    TerminalPosition45PRESSEDRELEASED

  • If the switch does not work as described in the table, replace the switch.

  • If the switch tests OK, go to step 3.

  1. On the switch side, check for continuity between the BSI OFF switch 6P connector terminals No. 1 and No. 2.   There should be continuity at all times.

    2. 6 5 4 3 2 1 BSI OFF SWITCH 6P CONNECTORTerminal side of male terminals?

  1. If the continuity is not as specified, remove the cover (A), and replace the bulb (B).

    2. BA

  1. Install the BSI OFF switch in the reverse order of removal.

    Brake Control and Vehicle Dynamics

    BSI OFF Switch Test/Removal/Installation

    See More:

    Honda Odyssey Owners Manual > Cruise Control: To Adjust the Vehicle Speed
    Increase or decrease the vehicle speed using the or buttons on the steering wheel. • Each time you press the button, the vehicle speed is increased or decreased by about 1 mph (1.6 km/h). • If you keep the button pressed, the vehicle speed increases or decreases until you release it. This speed ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0099