Honda Odyssey Service Manual: Rear Fuse Box (Rear MICU) Removal and Installation

Honda Odyssey Service Manual / Electrical / Fuses Junctions and Relays / Rear Fuse Box (Rear MICU) Removal and Installation

NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing.

Removal

  1. Do the battery terminal disconnection procedure.

  1. Remove the left rear side trim panel.

  1. Disconnect the connectors from the rear fuse box (A).

  2. ABB
  3. Remove the mounting bolts (B), then remove the rear fuse box.


Installation

  1. Connect the connectors to the rear fuse box, then install the rear fuse box in the reverse order of removal.

  1. Install the removed parts in the reverse order of removal.

  1. Do the battery terminal reconnection procedure.

  1. Confirm that all systems work properly.

    Fuses Junctions and Relays

    Driver's Under-Dash Fuse/Relay Box (Driver's MICU) Removal and Installation (Canada model)

    See More:

    Honda Odyssey Service Manual > Front Damper/Spring Removal and Installation: Removal
    Raise and support the vehicle. Remove the front wheel. Remove the wire guide rubber (A) and the clip (B) from the damper (C). Do not disconnect the wheel speed sensor connector. 8 x 1.25 mmABCD Remove the brake hose bracket (D) from the damper. Remove the flange nut (A), while holding the joint pin ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0093