Honda Odyssey Service Manual: Under-Hood Fuse/Relay Box Removal and Installation

Honda Odyssey Service Manual / Electrical / Fuses Junctions and Relays / Under-Hood Fuse/Relay Box Removal and Installation

Special Tools Required

  • Relay Puller 07AAC-000A2A1 or 07AAC-000A1A0

NOTE: The under-hood fuse/relay box is a part of the right engine compartment wire harness, and it cannot be replaced by itself.

Removal

  1. Do the battery terminal disconnection procedure.

  1. Remove the bolt (A), and release the tabs (B), then remove the bottom cover (C) from the under-hood fuse/relay box (D).

  2. ABCEFGDE
  3. Disconnect the connectors (E) from the under-hood fuse/relay box.

  4. Open the cover (F), then remove the relay control module (G) from the under-hood fuse/relay box.

  5. Carefully remove the relays by prying under the base of the relay.

    NOTE: Do not use pliers. Pliers will damage the relays, which could cause the engine to stall or not start or cause other functions to fail.


Installation

  1. Install the relays and connect the connectors to the under-hood fuse/relay box, then install the under-hood fuse/relay box in the reverse order of removal.

  1. Install the removed parts in the reverse order of removal.

  1. Do the battery terminal reconnection procedure.

  1. Confirm that all systems work properly.

    Installation

    HVAC

    See More:

    Honda Odyssey Service Manual > Side Windows: Sliding Door Glass Adjustment
    NOTE: Check the door glass outer weatherstrip and the glass run channel for damage or deterioration, and replace them if necessary. Wipe the run channel clean with a shop towel. Place the vehicle on a firm, level surface when adjusting the door glass. Remove the plastic cover. Lower the glass (A) un ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0799