Honda Odyssey Service Manual: Recirculation Control Motor Replacement

Honda Odyssey Service Manual / HVAC / Ventilation Doors / Recirculation Control Motor Replacement

Removal

  1. Remove the blower unit.

  1. Remove the self-tapping screws and the recirculation control motor (A) from the blower unit.

    2. A

Installation

  1. Make sure the damper lever pins in the motor lever are visible through the holes. Make sure the recirculation door and linkage move smoothly.

    2. Check here.

  1. While holding the recirculation control motor (A), install the self-tapping screws.

    2. A

  1. Install the blower unit.

  1. After installation, make sure the motor runs smoothly.

    Rear Mode Control Motor Replacement

    See More:

    Honda Odyssey Service Manual > Fuel/Charge Lid: Fuel Fill Door Opener Cable Replacement
    Special Tools Required KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS component locations   and the precautions and procedures   before doing repairs or service. NOTE: ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0099