Honda Odyssey Service Manual: BSI Radar Unit Removal/Installation

Honda Odyssey Service Manual / Accessories / Driver Assist / Blind Spot Monitor / BSI Radar Unit Removal/Installation

  1. Remove the rear bumper.

  1. Remove rear bumper side spacer B.

    2. BNOTE: This illustration shows left of the vehicle, right is similar.

  1. Remove the BSI radar unit (A).

    1. Disconnect the 6P connector (B).

    1. Remove the bolts.

    2. BA6 x 1.0 mm 9.4 N·m (0.96 kgf·m, 6.9 lbf·ft)NOTE: This illustration shows left of the vehicle, right is similar.

  1. Install the BSI radar unit in the reverse order of removal, and note these items:

    • Make sure the BSI radar unit surface is clean.

    • Do the BSI radar unit aiming inspection.

    BSI Radar Unit Mounting Area Check

    BSI Radar Units

    See More:

    Honda Odyssey Service Manual > Dashboard Assembly: Dashboard Driver's Middle Panel Removal/Installation
    Special Tools Required KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: Take care not to scratch the dashboard or the related parts. Use the appropriate tool from the KTC trim tool set to avoid damage when removing components. Remove the d ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0096