A LATCH-compatible child seat can be installed in each of the second and third row seats. A child seat is attached to the lower anchors with either the rigid or flexible type of connectors. 1. Locate the lower anchors under the marks. 2. Place the child seat on the vehicle seat then
attach the child seat to the lower anchors
according to the instructions that came
with the child seat. Second row center seat To install a LATCH-compatible child seat in the second row center seat, remove the covers on each lower end of the seat -back by pulling on the handles. For your child's safety, when using a child seat installed using the LATCH system, make sure that the seat is properly secured to the vehicle. A child seat that is not properly secured will not adequately protect a child in a crash and may cause injury to the child or other vehicle occupants. 3. Raise the head restraint to its highest
position, then route the tether strap
between the head restraint legs, and secure
the tether strap hook onto the anchor. 6. Make sure any unused seat belt that a child can reach is buckled, the lockable retractor is activated, and the belt is fully retracted and locked. |
Honda Odyssey Service Manual > Fuses Junctions and Relays: Rear Fuse Box (Rear MICU) Removal and
Installation
NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures before doing repairs or servicing. Removal Do the battery terminal disconnection procedure. Remove the left rear side trim panel. Disconnect the connectors from the rear fuse ...