Honda Odyssey Service Manual: Navigation Display Visor Removal/Installation

NOTE:

• Do this procedure in a clean place free from dirt.

• Wear latex or vinyl gloves when doing this procedure (Do not use fabric gloves).

• When removing the navigation display visor, do not touch the LCD facing.

• If there is dirt on the LCD facing, clean it using compressed air.

• When installing the navigation display visor onto the LCD assembly, be careful not to touch the LCD facing.

• Check that the navigation display visor and the LCD assembly are properly installed.

• Since the LCD assembly and the navigation display visor are installed at an angle, be sure that the screws are properly seated. If not properly seated, tighten the screws.

• Check that the navigation display unit assembly has no damage.

• When removing the navigation display visor, do not hold the LCD facing down.

1. Remove the navigation display unit.

2. Remove the screws and the LCD assembly (A) from the navigation display visor (B).

3. Remove the screws (A) and the front passenger's airbag cutoff indicator (B) from the navigation display visor (C).

4. Install the navigation display visor reverse order of removal.