Honda Odyssey Service Manual: Hood Assembly

Hood Release Handle Replacement

NOTE: Take care not to kink the hood opener cable.

  1. Remove the driver's kick panel.

  1. Remove the bolts, then remove the hood release handle (A).

  2. 6 x 1.0 mm9.3 N·m(0.95 kgf·m,6.9 lbf·ft)ABFastener Locations? : Bolt, 2
  3. Disconnect the hood opener cable (B).

  4. Install the hood release handle in the reverse order of removal, and note these items:

    • Make sure the cable is connected properly.

    • Make sure the hood opens properly.

Hood Latch Replacement

NOTE:

  • Put on gloves to protect your hands.

  • Take care not to scratch the body or the related parts.

  1. Remove the front bulkhead cover.

  1. Remove the bolts, then remove the hood latch (A), and disconnect the hood opener cable (B).

  2. Fastener Locations? : Bolt, 3BAC6 x 1.0 mm11 N·m (1.1 kgf·m, 8 lbf·ft)
  3. For some models: Disconnect the security hood switch connector (C).

  1. Install the latch in the reverse order of removal, and note these items:

    • Apply multipurpose grease to each location on the hood latch indicated by the arrows.

    • Make sure the cable is connected properly, and the connector is plugged in properly.

    • Adjust the hood latch alignment.

    • Make sure the hood opens properly and locks securely.

  2. ?????
    Fuel Fill Door Opener Cable Replacement

    Handles and Remote Openers

    See More:

    Honda Odyssey Service Manual > Vertical and Horizontal Adjustment at the Rear: Special Tools Required
    KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: If you remove the door upper molding, replace it with a new one because it will bend during removal. Put on gloves to protect your hands. Take care not to scratch the door. Use the appropri ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2024 Copyright www.hodyssey.net
    0.0083