Honda Odyssey Service Manual: Fuel Fill Door Opener Cable Replacement

Special Tools Required

• KTC Trim Tool Set SOJATP2014

*Available through the Honda Tool and Equipment Program; call 888-424-6857

SRS components are located in this area. Review the SRS component locations   and the precautions and procedures   before doing repairs or service.

NOTE:

• Put on gloves to protect your hands.

• Take care not to scratch the body or the related parts.

• Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove these items:

   • Kick panel, driver's side

   • Front door sill trim, driver's side

   • Sliding door sill trim, driver's side

   • B-pillar lower trim, driver's side

   • Rear side trim panel, left side

1. Pull the carpet back as needed.

3. Disconnect the fuel fill door opener cable (A) from the opener (B).

4. Detach the clips (C, D, E) from the body with a clip remover. Release the opener cable from the clip (F, G, H), and remove the cushion tape pieces (I), then remove the fuel fill door latch (J) from the body by turning it 90 °.

5. Remove the fuel fill door opener cable from the vehicle.

   NOTE: Take care not to bend or kink the cable.

1. Install the opener cable in the reverse order of removal, and note these items:

   • If the clips are damaged or stress-whitened, replace them with new ones.

   • Route the cable beside the floor wire harness.