Release the cable holder (A) and the fastener (B), then disconnect the outer handle cable (C).
Remove the plug cap (A).
Remove the bolt, then remove the outer handle protector (A).
Remove the outer handle spacer (A).
Disconnect the door outer handle connector (B).
Detach the harness clips (C, D).
Remove the bolt.
Hold the outer handle base (A) and pull out on the outer handle (B) to raise the outer handle weight (C).
While holding the outer handle (A) as describe above, roll the
top edge of the outer handle base (B) down, and pull the outer handle
base out from the door, then slide the outer handle forward to remove
it.
Remove the cable fastener (A) from the outer handle (B), then replace it with a new one.
Install the outer handle in the reverse order of removal, and note these items:
Make sure the connector is plugged in properly, and the cable is connected securely.
Make sure the door lock and the door handle operate properly.
Make sure the plastic cover on the door is installed properly and sealed around its outside perimeter to seal out water.
Honda Odyssey Service Manual > Manual Seat Controls: Third Row Seat Latch Replacement
Special Tools Required KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Take care not to tear or damage the seat covers. Use the appropriate tool from the KTC trim tool set to avoid damage when removing ...