Honda Odyssey Service Manual: Gauge Control Module Replacement

Honda Odyssey Service Manual / Body / Driver Info & Control / Gauges / Gauge Control Module Replacement

NOTE: Before replacing the gauge control module, retrieve the ODO data from the gauge control module with the HDS.

  1. Turn the ignition switch to LOCK (0).

  1. Remove the instrument visor.

  1. Remove the three screws from the gauge control module (A).

    2. BA

  2. Disconnect the 32P connector (B) from the gauge control module.

  3. Install the gauge control module in the reverse order of removal.

  4. Rewriting the ODO data on a new gauge control module.

    NOTE: Check the official Honda website for more information on how to write odometer information to a gauge control module that will not communicate with the HDS.

    Gauges

    Rewriting the ODO Data on a New Gauge Control Module

    See More:

    Honda Odyssey Service Manual > Crash Sensors: Side Impact Sensor (Third) Replacement
    Removal Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work. Remove the rear side trim panel. Disconnect the side impact sensor (third) 4P connector (A) on the left or right side wire harness. Left side ABC Right side ABDC Remove the TORX bolt (B) using ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0191