Honda Odyssey Service Manual: Yaw Rate-Acceleration Sensor Replacement

Honda Odyssey Service Manual / Body / Restraints / Restraints Control / Crash Sensors / Yaw Rate-Acceleration Sensor Replacement

NOTE:

  • Do not damage or drop the sensor as it is sensitive.

  • Do not use power tools when replacing the sensor.

  • Check the sensor bracket for a deformation.

  1. Turn the ignition switch to LOCK (0).

  1. Remove the center lower console.

  1. Remove the yaw rate-acceleration sensor (A).

  2. AB6 x 1.0 mm9.4 N·m (0.96 kgf·m, 6.9 lbf·ft)
  3. Disconnect the yaw rate-acceleration sensor 4P connector (B).

  1. Install the yaw rate-acceleration sensor in the reverse order of removal.

  1. Do the VSA sensor neutral position memorization.

    Side Impact Sensor (Third) Replacement

    Occupant Classification System

    See More:

    Honda Odyssey Service Manual > Rear Knuckle/Hub Bearing Unit Replacement: Hub Bearing Unit Replacement
    Raise and support the vehicle. Remove the wheel nuts (A) and the wheel. A14 x 1.5 mm127 N·m(13.0 kgf·m, 94 lbf·ft) Remove the brake hose mounting bolt (A). CB12 x 1.25 mm88 N·m (9.0 kgf·m, 65 lbf·ft)A8 x 1.25 mm 21 N·m (2.1 kgf·m, 15 lbf·ft) Remove the brake caliper bracket mounting bolts ( ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0119