NOTE:
After a collision where the front seat belt tensioners deployed, replace these items:
After a collision where the driver's seat belt outer lap tensioner deployed, replace these items:
After a collision where the front airbag(s) deployed, replace these items:
After a collision where the side airbag has deployed, replace the items for the side(s) that deployed:
After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed. A-Pillar Upper Trim B-Pillar Upper/Lower Trim C-Pillar Trim D-Pillar Trim During the repair process, inspect these areas:
After the vehicle is completely repaired, turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode. If the SRS indicator comes on for about 6 seconds and then goes off, the SRS is OK. If the indicator does not function properly, use the HDS to check for the DTCs. If you cannot retrieve a code, do the SRS Symptom Troubleshooting. |
Honda Odyssey Service Manual > Wipers, Washers: Wiper Motor Replacement
Windshield NOTE: Be careful not to scratch or damage the hood and the body. Remove the windshield wiper arms. Remove the cowl cover. Disconnect the 5P connector (A) from the windshield wiper motor (B). AC9.4 N?m (0.96 kgf?m, 6.9 lbf?ft)BD Remove the three bolts (C) and wiper linkage assembly (D). Re ...