Honda Odyssey Service Manual: Checking and Adjusting the Headliner/Pillar Trim Overlap

Honda Odyssey Service Manual / Body / Restraints / Secondary / Checking and Adjusting the Headliner/Pillar Trim Overlap

To prevent the side curtain airbag from deploying and damaging the pillar trim (A-pillar trim, B-pillar trim, C-pillar trim, D-pillar trim), the overlap between the headliner and pillar trim must be less than 8 mm(0.31 in)   To check the overlap, do this:

NOTE: This illustration shows the A-pillar.

  1. Install the headliner (A) and the pillar trim (B).

  2. AB
  1. Apply masking tape (A) to the headliner (B) to mark the upper edge of the pillar trim (C).

  2. ABC
  1. Remove the pillar trim, and measure the headliner overlap.

    • If the overlap is less than 8 mm (0.31 in), remove the tape, and install the pillar trim.

    • If the overlap is more than 8 mm (0.31 in), go to step 4.

  2. EDGE OF HEADLINERLESS THAN8 mm (0.31 in)MASKING TAPE
  1. Carefully trim the headliner with a utility knife, reducing the overlap to less than 8 mm (0.31 in).

  2. Remove the tape, and install the pillar trim.

    SRS Component Replacement/Inspection After Deployment

    Airbag and Tensioner Disposal

    See More:

    Honda Odyssey Service Manual > Doors: Vertical and Horizontal Adjustment at the Rear
    Adjust the center roller (A), the front striker (B) and the rear striker (C). Loosen the center roller bolts (D). Move the door in or out until it is flush with the body, and up or down to equalize the gaps. If necessary, adjust the door cushion (E) to make the door fit flush with the body. Tighten ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0166