Honda Odyssey Service Manual: Headrests

Front Seat Active Head Restraint Inspection

NOTE: If the vehicle has been in a collision, always inspect the active head restraint, even if they appear reusable, by doing the following procedure.

  1. Move the seat-back to the fully upright position. Raise the head restraint to the highest position.

  1. Apply the masking tape (A) on the top of the head restraint (B).

  2. BCA
  3. Make the mark (C) at the center point of the head restraint. Use the mark for the measurements in step 4.

  1. Push the head restraint (A) forward, and measure the horizontal head restraint movement. The head restraint should move more than 50 mm (1.96 in) without resistance. If it is less than 50 mm (1.96 in), or the head restraint does not move smoothly, replace the seat frame.

  2. Above 50 mm (1.96 in)(Level)A
    Seating

    Lumbar Support

    See More:

    Honda Odyssey Service Manual > Body Exterior: Roof Molding Replacement
    Special Tools Required KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: Take care not to scratch the body. The steel core in the roof molding can not be restored to its original shape once it is bent. Replace the roof molding if the steel ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.006