Honda Odyssey Service Manual: Lumbar Support

Honda Odyssey Service Manual / Body / Seating / Lumbar Support

Power Lumbar Support Switch Test/Replacement

NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing.

  1. Remove the driver's recline cover.

  1. Disconnect the 5P connector from the lumber support switch (A), then separate the cover (B).

    2. 1 2 3 4 5 AB

  1. Check for continuity between the terminals in each switch position according to the table.

    2. ForwardBackwardTerminalPosition12345*???????*?

    *: There is continuity without operating a switch.

  2. If the continuity is not as specified, replace the switch.

  3. Install the switch in the reverse order of removal.

    Headrests

    Seat Controls

    See More:

    Honda Odyssey Service Manual > Alternator Overhaul: Alternator Reassembly
    If you removed the OAD pulley, install it. Remove any grease or any oil from the slip rings. Put the rear housing assembly and the drive-end housing/rotor assembly together, tighten the four through bolts. Push the brushes (A) in, then insert a pin or drill bit (B) (about 1.6 mm (1/16 in) diameter) ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0058