Honda Odyssey Service Manual: Driver's Power Seat Adjustment Switch Test/Replacement

Honda Odyssey Service Manual / Body / Seating / Seats / Driver's Power Seat Adjustment Switch Test/Replacement

Driver's Seat without DPMS

NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing.

  1. Remove the driver's seat recline cover.

  1. Disconnect the 12P connector from the power seat adjustment switch (A).

    2. 1 2 3 4 5 6 7 8 9 10 1 1 1 2 AB

  2. Remove the power seat adjustment switch knobs (B) and remove the two screws, then remove the switch.

  3. Reinstall the adjustment switch knobs to the switch.

  1. Check for continuity between the terminals in each switch position according to the table.

    2. TerminalPositionSLIDESWITCHForwardBackward1RECLINESWITCHForwardBackwardFRONTUP-DOWNSWITCHUPDOWNREARUP-DOWNSWITCHUPDOWN23456789101112??*????*????*????*?????*?*????*??????*??*: There is continuity without operating a switch.

  2. If the continuity is not as specified, replace the switch.

  3. Install the switch in the reverse order of removal.

    Seats

    Front Passenger's Power Seat Adjustment Switch Test/Replacement

    See More:

    Honda Odyssey Service Manual > Brake Control and Vehicle Dynamics: Suspension Stroke Sensor Replacement
    Raise the vehicle, make sure it is securely supported. Disconnect the 3P connector (A) from the suspension stroke sensor (B). Front ABDo not disassemble.D9.4 N?m (0.96 kgf?m, 6.9 lbf?ft)Replace.C Rear A9.4 N?m (0.96 kgf?m, 6.9 lbf?ft)Do not disassemble.BCD Remove the bolt(s) (C) and the nut (D), the ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0079