Honda Odyssey Service Manual: Brake Booster Replacement

Honda Odyssey Service Manual / Chassis / Brakes / Hydraulic Brakes / Brake Booster Replacement

  1. Remove the air cleaner.

  1. Remove the master cylinder.

  1. Remove the brake lines (A) from the VSA modulator-control unit (B).

  2. A22 N·m(2.2 kgf·m,16 lbf·ft)BC
  3. Disconnect the brake booster vacuum hose (C) from the brake booster.

  1. Remove the lock pin (A) and the clevis pin (B), then disconnect the clevis from the brake pedal.

  2. C8 x 1.25 mm12 N·m(1.2 kgf·m,9 lbf·ft)BA?
  3. Remove the brake booster mounting nuts (C).

  1. Remove the brake booster (A) from the engine compartment.

    NOTE:

    • Be careful not to damage the brake booster mounting surfaces and the threads on the booster studs.

    • Be careful not to bend or damage the brake lines.

    • Use a new brake booster gasket (B) during reassembly.

  2. ABReplace.
  3. Install the brake booster in the reverse order of removal, and note these items:

    • Install the master cylinder after installing the brake booster.

    • Check the brake pedal height and free play after installing the master cylinder, and adjust it if necessary.

    • Bleed the brake system.

    Hydraulic Brakes

    Brake Hose Replacement

    See More:

    Honda Odyssey Service Manual > Driver Info & Control: Center Display Lens Removal/Installation
    NOTE: Do this procedure in a clean place free from dirt and dust. Wear latex or vinyl gloves when doing this procedure (Do not use fabric gloves). When removing the center display lens, do not touch the LCD facing. If there is dirt on the LCD facing, blow it clean with compressed air. When installin ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2025 Copyright www.hodyssey.net
    0.0104