Honda Odyssey Service Manual: Front

Honda Odyssey Service Manual / Chassis / Brakes / Hydraulic Brakes / Front

  1. Raise and support the vehicle.

  1. Remove the front wheel.

  1. Disconnect the brake line (A) from the brake hose (B), then remove the brake hose clip (C).

    2. A10 x 1.0 mmBCReplace.

  1. Remove the banjo bolt (A), and disconnect the brake hose (B) from the caliper body.

    2. C8 x 1.25 mmBA

  2. Remove the brake hose mounting bolt (C), then remove the brake hose.

  1. Install the brake hose (A) with the mounting bolt (B).

    2. AB8 x 1.25 mm 21 N·m (2.1 kgf·m, 15 lbf·ft)C10 x 1.0 mm 35 N·m (3.6 kgf·m, 26 lbf·ft)DReplace.

  2. Connect the brake hose to the caliper body with the banjo bolt (C) and new sealing washers (D).

  1. Install the new brake hose clip (A) to the brake hose (B)   on the bracket, then connect the brake line (C). Do not twist the brake hose.

    2. C10 x 1.0 mm 15 N·m (1.5 kgf·m, 11 lbf·ft)BAReplace.

  2. After installing the brake hose, bleed the brake system.

  3. Do the following checks:

    • Check the brake hose and line joint for leaks, and tighten if necessary.

    • Check the brake hoses for interference and twisting.

  4. Clean the mating surfaces between the brake disc and the inside of the wheel, then install the front wheel.


    Brake Hose Replacement

    Rear

    See More:

    Honda Odyssey Service Manual > Keyless Security System: Keyless Access Control Unit
    The keyless access control unit is located in the driver's side of the dashboard assembly. The control unit detects the remotes which allows access using the touch sensors in the outer door handles, and also allows the vehicle to operate using the one push start. The keyless access control unit can ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0271