Honda Odyssey Service Manual: Rear

Honda Odyssey Service Manual / Chassis / Brakes / Hydraulic Brakes / Rear

  1. Raise and support the vehicle.

  1. Remove the rear wheel.

  1. Disconnect the brake lines (A) from the brake hose (B),   then remove the brake hose clips (C).

    2. A10 x 1.0 mmBCReplace.

  1. Remove the banjo bolt (A), and disconnect the brake hose (B) from the caliper body.

    2. ABC8 x 1.25 mm

  2. Remove the brake hose mounting bolt (C), then remove the brake hose.

  1. Install the brake hose (A) with the mounting bolt (B).

    2. C10 x 1.0 mm35 N·m(3.6 kgf·m, 26 lbf·ft)DReplace.AB8 x 1.25 mm 21 N·m (2.1 kgf·m, 15 lbf·ft)

  2. Connect the brake hose to the caliper body with the banjo bolt (C) and new sealing washers (D).

  1. Install the new brake hose clip (A) to the brake hose (B)   on the bracket, then connect the brake line (C).   Do not twist the brake hose.

    2. C10 x 1.0 mm 15 N·m (1.5 kgf·m, 11 lbf·ft)BAReplace.

  1. After installing the brake hose, bleed the brake system.

  1. Do the following checks:

    • Check the brake hose and line joint for leaks, and tighten if necessary.

    • Check the brake hoses for interference and twisting.

  1. Clean the mating surfaces between the brake disc/drum and the inside of the wheel, then install the rear wheel.

    Front

    Brake Hose and Line Inspection

    See More:

    Honda Odyssey Owners Manual > Handling the Unexpected: Jump Starting
    WARNING A battery can explode if you do not follow the correct procedure, seriously injuring anyone nearby. Keep all sparks, open flames, and smoking materials away from the battery. Securely attach the jumper cables clips so that they do not come off when the engine vibrates. Also be careful not to ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.03