Honda Odyssey Service Manual: Installation

Install the bump stop (A) to the body if removed.

Install the spring (A), spring mounting cushion (C), and the lower spring seat (D). Align the bottom of the spring with the stepped part of the lower spring seat and lower arm B as shown.

Position a floor jack under lower arm B. Raise the floor jack until the hole in lower arm B aligns with the hole in the knuckle, then loosely install the new flange bolt (A) to the knuckle.

Raise the rear suspension with the floor jack to load the suspension with the vehicle's weight.

Tighten the flange bolt to the specified torque.

Clean the mating surfaces between the brake disc/drum and the inside of the wheel, then install the rear wheel.

Check the wheel alignment, and adjust it if necessary.