Honda Odyssey Service Manual: Wheel Bearing End Play Inspection

Honda Odyssey Service Manual / Chassis / Suspension / Wheel Bearing End Play Inspection

  1. Raise and support the vehicle.

  1. Remove the wheels.

  1. Install suitable flat washers (A) and the wheel nuts (B). Tighten the nuts to the specified torque to hold the brake disc or the brake disc/drum securely against the hub.

  2. Front

    B14 x 1.5 mm127 N·m(13.0 kgf·m, 94 lbf·ft)A

    Rear

    B14 x 1.5 mm127 N·m(13.0 kgf·m, 94 lbf·ft)A
  3. Attach the dial gauge. Place the dial gauge against the hub flange.

  4. Measure the bearing end play while moving the brake disc or the brake disc/drum inward and outward.

    Wheel bearing end play:

    Front/Rear: 0-0.05 mm (0-0.0020 in)

  5. If the bearing end play measurement is more than the standard, replace the hub bearing unit.

    Knuckle Replacement

    Front Knuckle/Hub Bearing Unit Replacement

    See More:

    Honda Odyssey Service Manual > Hydraulic Power Steering Pump Overhaul: Inspection
    Check the flow control valve for wear, burrs, and other damage to the edges of the grooves in the valve. Inspect the bore of the flow control valve on the pump housing for scratches and wear. Slip the flow control valve back in the pump housing, and check that it moves in and out smoothly. If OK, g ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0241