Honda Odyssey Service Manual: Exploded View

Honda Odyssey Service Manual / Chassis / Suspension / Front Knuckle/Hub Bearing Unit Replacement / Exploded View

FLANGE NUTReplace.SPLASH GUARDCheck for corrosion,deformation, rust, and damage.HUB BEARING UNIT(MAGNETIC ENCODER)Check for faultymovement and wear.FRONT BRAKE DISCCheck for wear, damage, and rust.SPINDLE UNIT26 x 1.5 mm328 N·m(33.4 kgf·m, 242 lbf·ft)Replace.Apply a small amount of engine oilto the seating surface of the nut.KNUCKLECheck for deformation anddamage.DAMPER PINCH BOLT16 x 1.5 mm175 N·m(17.8 kgf·m, 129 lbf·ft)Replace.FLATHEAD SCREW6 x 1.0 mm9.3 N·m(0.95 kgf·m,6.9 lbf·ft)12 x 1.25 mm98 N·m(10.0 kgf·m, 72 lbf·ft)?

Special Tools Required

  • Ball Joint Thread Protector, 12 mm 07AAF-SDAA100
  • Ball Joint Remover, 28 mm 07MAC-SL0A202
  • Ball Joint Thread Protector, 14 mm 071AF-SZNA100
  • Ball Joint Remover, 32 mm 07MAC-SL0A102

NOTE: Refer to the Exploded View as needed during the following procedure.

    Front Knuckle/Hub Bearing Unit Replacement

    Hub Bearing Unit Replacement

    See More:

    Honda Odyssey Service Manual > Crash Sensors: Rear Safing Sensor Replacement
    Removal Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work. Raise both third row seats up, and secure them. Remove the left and right lower pivot cover. Remove the center lower pivot cover. Remove the left and right upper pivot cover. Remove the center ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0271