Honda Odyssey Service Manual: Knuckle Replacement

  1. Remove the hub bearing unit.

  1. Remove the wheel speed sensor (A) from the knuckle (B). Do not disconnect the wheel speed sensor connector.

  2. AB6 x 1.0 mm9.3 N·m (0.95 kgf·m, 6.9 lbf·ft)
  1. Remove the cotter pin (A) from the tie-rod end ball joint, then remove the nut (B).

    NOTE: During installation, install the new cotter pin after tightening the new nut, and bend its end as shown.

  2. AReplace.B12 x 1.25 mm60 N·m(6.1 kgf·m,44 lbf·ft)Replace.07MAC-SL0A20207AAF-SDAA100
  3. Disconnect the tie-rod end ball joint from the knuckle using the ball joint thread protector and the ball joint remover.


  1. Remove the lock pin (A) from the lower arm ball joint, then remove the castle nut (B).

    NOTE: During installation, install the lock pin as shown after tightening the new castle nut.

  2. AB14 x 2.0 mm64-74 N·m(6.5-7.5 kgf·m, 47-55 lbf·ft)Replace.07MAC-SL0A102071AF-SZNA100
  3. Disconnect the lower arm ball joint from the knuckle using the ball joint thread protector and the ball joint remover.

    NOTE:

    • Be careful not to damage the ball joint boot when installing the remover.

    • Do not force or hammer on the lower arm, or pry between the lower arm and the knuckle. You could damage the ball joint.

  1. Remove the damper pinch bolts (A) and flange nuts (B) from the damper, then remove the knuckle (C).

    NOTE: During installation, install new damper pinch bolts and a new flange nuts.

  2. BReplace.CA16 x 1.5 mm175 N·m(17.8 kgf·m, 129 lbf·ft)Replace.
  3. Install the knuckle in the reverse order of removal, and note these items:

    • Be careful not to damage the ball joint boot when connecting the knuckle.

    • Before connecting the ball joint to the knuckle, degrease the threaded section and the tapered portion of the ball joint pin, the ball joint connecting hole, the threaded section and the mating surfaces of the castle nut.

    • Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the ball joint pin hole. Do not align the castle nut by loosening it.

  4. Check the wheel alignment, and adjust it if necessary.

    Hub Bearing Unit Replacement

    Rear Knuckle/Hub Bearing Unit Replacement

    See More:

    Honda Odyssey Service Manual > Seats: Rear
    Second Row Center Seat Cushion Cover Replacement Special Tools Required KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Take care not to tear or damage the seat covers. Use the appropriate tool from th ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2024 Copyright www.hodyssey.net
    0.0139