Honda Odyssey Service Manual: Installation

Honda Odyssey Service Manual / Electrical / Charging / Over-Run Alternator Decoupler (OAD) Pulley Removal and Installation / Installation

  1. Loosely tighten the OAD pulley (A), then insert the alternator OAD pulley holder (B) into the OAD pulley.

    2. B07AAB-TK8A100A

  1. Place a 10 mm deep socket wrench (A) through center of the alternator OAD pulley holder (B), onto the hex on the end of the alternator shaft.

    2. ABC

  2. Hold the alternator OAD pulley holder with a 17 mm wrench (C), then tighten the alternator shaft counterclockwise to the specified torque.

    Specified Torque:

    80 N·m (8.2 kgf·m, 59 lbf·ft)

  1. Install the new OAD pulley seal cap (A).

    NOTE:

    • When installing do not distort the OAD pulley seal cap.

    • Make sure to check that the cap is installed securely.

    2. AReplace.

  1. Install the alternator.

    Removal

    Data and Communication Network

    See More:

    Honda Odyssey Owners Manual > Controls: Setting the Clock
    Clock You can adjust the time in the clock display, using the CLOCK button with the ignition switch in ON . 1. Press the CLOCK button to access the clock adjustment mode screen. 2. Press to select the item you want to adjust (12/24 hour mode, hour, minute). 3. Rotate to make the adjustment. 4. Press ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0072