Honda Odyssey Service Manual: FCW/LDW Camera Unit 10P Connector Inputs and Outputs

Honda Odyssey Service Manual / Accessories / Driver Assist / Lane Departure Warning / FCW/LDW Camera Unit 10P Connector Inputs and Outputs

1 2 3 4 5 6 7 8 9 1 0 Wire side of female terminalsFCW/LDW CAMERA UNIT 10P CONNECTOR

Terminal
number

Wire color

Terminal
name

Description

Signal

1

WHT

LDW SW

Detects LDW OFF switch signal

Vehicle in ON mode: Battery voltage
Vehicle in OFF mode: About 0 V

2

GRN

IG1 METER

Power supply for the FCW/LDW camera unit

Vehicle in ON mode: Battery voltage
Vehicle in OFF mode: About 0 V

5

BLK

F-CAN L

F-CAN communication (low) circuit

???

6

WHT

F-CAN H

F-CAN communication (high) circuit

???

7

PUR

LDW SW IND

Drive LDW OFF switch circuit

LDW OFF switch pressed: About 0 V

8

GRN

+B BACK UP

Power supply for backup memory

Battery voltage

10

BLK

GND

Ground circuit for the FCW/LDW camera unit

Less than 0.2 V at all times

    Lane Departure Warning (LDW) System

    LaneWatch   System

    See More:

    Honda Odyssey Service Manual > Blind Spot Monitor: BSI Radar Unit Removal/Installation
    Remove the rear bumper. Remove rear bumper side spacer B. BNOTE: This illustration shows left of the vehicle, right is similar. Remove the BSI radar unit (A). Disconnect the 6P connector (B). Remove the bolts. BA6 x 1.0 mm 9.4 N·m (0.96 kgf·m, 6.9 lbf·ft)NOTE: This illustration shows left of the ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2023 Copyright www.hodyssey.net
    0.0074