Honda Odyssey Service Manual: License Plate Light Replacement

Honda Odyssey Service Manual / Body / Body Electrical / Lighting / Headlight Leveling Motors / License Plate Light Replacement

  1. Remove the tailgate lower trim panel.

  1. Push the license plate light (A) to the side to release the retaining spring, and pull out the license plate light.

    2. A

  1. Disconnect the 2P connector (A) from the light.

    License Plate Light:5 W
    2. ABCD

  2. Separate the lens (B) and the housing (C), then remove the bulb (D).

  3. Install the license plate light in the reverse order of removal.

    Sunlight Sensor Replacement (With Climate Control)

    Combination Light Switch Test/Replacement

    See More:

    Honda Odyssey Service Manual > Over-Run Alternator Decoupler (OAD) Pulley Removal and Installation: Removal
    Remove the alternator. Clamp the alternator firmly in a vise. Remove the over-run alternator decoupler (OAD) pulley seal cap (A) by piercing the center of the rubber cap with a flat screwdriver and prying it loose. NOTE: While the cap is off, the grease inside the OAD pulley is exposed. Do not wipe ...

    Honda Odyssey Owners Manual

    Honda Odyssey Service Manual

    © 2018-2026 Copyright www.hodyssey.net
    0.0084